Setting Gainer
by admin on 2 月.10, 2009, under USB controlle
It is to solder a pin first to have to do. Gainer can install two lines of pins. I put Gainer on the top to install it precisely after having inserted a pin in a flexible board. When I solder it, please be careful heat comes not too much, and not to break a part.
No comments for this entry yet...
Leave a Reply
You must be logged in to post a comment.
-
Howdy. Welcome to Second Physical Communication Laboratory!
Thanks for dropping by! Feel free to join the discussion by leaving comments, and stay updated by subscribing to the RSS feed. See ya around!
